EOS EMOTEC B6000 User's Guide download pdf (Page 16)

16 GB

Error display

To quickly diagnose possible errors, use the error code explanation below to ascertain the

type of error.

Error code Error

E 100 temperature sensor interruption/disconnection

E 101 temperature sensor short circuit

E 211 overheat safety shutoff interruption/disconnection

The warning symbol blinks whenever an error message is displayed, so you may

easily recognize an error.

Additional errors not displayed and their causes:

Blank display - display not backlit

Check the power supply! All three phases L1, L2, L3 must be connected to 230 V AC.

Check all fuses.

Check the microfuse on the circuit board. You may use a 100 mA / T type fuse for

replacement.

In case of breakdown, press the control

unit switch on the left part of the rocker to

the first position (switch position 0). The

unit is now completely switched off.

The control unit switch

The control unit switch can be found on the

top end of the unit. Using this

switch, you can isolate the electronics from

the mains supply in case of a breakdown.

Please note that operating the control unit

switch returns all settings to the factory

settings.

In order to switch on the light in the sauna

when the unit is switched off, press on the

left part of the rocker to the second position

(switch position II).

In order to put the unit back into operation,

switch back to the starting position (switch

position I).

Control unit switch

= unit

switched

= unit

switched

off

= light

switched

1 2 ... 11 12 13 14 15 16 17 18 19

No comments

EOS EMOTEC B6000 User's Guide Page 16